Wiring A 3 Phase Panel. Different colors represent different phases. So the neutral wire is connected to all light indicators.
Pin on electrics electronics from www.pinterest.com
Review you have all the components. There should be five slots inside the plug corresponding to the five wires you will be attaching. Keep in mind that the total load should never exceed the rated capacity of the 3 phase panel.
And For Each Indicator There Own Line Wire.
Using a screwdriver, loosen the terminals on the breaker. Different colors represent different phases. Solar kit (2 additional current transformers, 1 additional wire tap) 2.
Locate The Ground Entering The Panel, Place It Under A Ground Bar Lug, And Tighten Until.
These light indicators rated voltage is 220 volts. Turn off the main breaker in your electrical panel. Turn off the main breaker.
Place One Of The Wires Under Each Lug On The Breaker And Tighten Until Snug.
These slots should be labeled 1,. If it does, that means. Keep in mind that the total load should never exceed the rated capacity of the 3 phase panel.
Remove The Screws On The Corners.
Web run three wires from the electrical panel to the device you wish to send power to. So the neutral wire is connected to all light indicators. A machine imported from taiwan has four connectors:
That Means The Total Load On The 3 Phase Panel Is 4160 Watts.
In thailand we usually use 3 phases (l1, l2, l3) + neutral (n) + ground (pe) with 220v. Three hot wires carrying 120 volts of electricity and one neutral. There should be five slots inside the plug corresponding to the five wires you will be attaching.
